You are visiting a website that is not intended for your region

The page or information you have requested is intended for an audience outside the United States. By continuing to browse you confirm that you are a non-US resident requesting access to this page or information.

Switch to the US site

Advanta VXT Vascular Graft

Advanta VXT Vascular Graft

Advanta VXT Vascular Graft

Two-layer reinforced grafts

Overview

The Advanta VXT vascular graft is a synthetic vascular prosthesis made from expanded Polytetrafluoroethylene (ePTFE).  It is comprised of a reinforced two-layer design to offer greater strength to that of Getinge’s single layer ePTFE grafts.  The Advanta VXT vascular graft is available in straight and tapered configurations offering the ability to match or alter vessel flow dynamics.  VXT grafts are also offered with and without helical support (commonly referred to as rings) should additional radial support be preferred.  Additionally, grafts can be ordered as standard wall thickness or thin wall thickness.

Straight

Getinge offers an extensive line of straight grafts.  Straight grafts are often used for those applications where a bypass is needed and vessel diameter remains a constant from the proximal to the distal anastomosis.

Tapered

A wide selection of tapered grafts is also offered for those clinical applications where flow dynamics need to be altered or when performing a bypass between two different diameter vessels.

Each of the above graft configurations is offered in both thin wall and standard wall thickness.

Thin Wall (TW)

To offer physicians improved suturability and handling, the Advanta VXT TW grafts offer a reduced wall thickness across the length of the graft.

Standard Wall (SW)

Getinge also offers a full line of standard wall thickness grafts.

Helix

Advanta VXT grafts are also offered with a helical coil (made of ePTFE) that is wrapped around the outer surface of the graft.  This helix provides additional radial support to minimize graft compression.  Common uses for a helix wrapped graft would be when graft placement falls across a joint, where unwanted compression of the graft is likely to occur.  Unlike competing products, our helix can be peeled off (by following the procedure in the product IFU) so that it will only be present where desired.

Advanta VXT has an average outer surface porosity of 50 μm

Advanta VXT has an inner surface porosity of nominal 20 μm

  • Advanta VXT is available in lengths from 10 – 90 cm
  • Advanta VXT is offered in diameters from 4 mm – 10 mm
  • Advanta VXT comes equipped with the Slider GDS tunneling system
  • Advanta VXT has an average outer surface porosity of 50 µm and an average inner surface porosity of 20 µm. [1]

All references

  1. 1. Data on file.